Always there to help you
Register your product and get support at
DS7880/37
Question?
Contact
Philips
User manual
moisture, does not operate normally, or
has been dropped.
1 Important
Battery usage CAUTION –To prevent
battery leakage which may result in bodily
injury, property damage, or damage to the
unit:
m
Safety
•
•
•
•
Install all batteries correctly, + and - as
marked on the unit.
Do not mix batteries (old and new or
carbon and alkaline, etc.).
Remove batteries when the unit is not
used for a long time.
Batteries (battery pack or batteries
installed) shall not be exposed to
excessive heat such as sunshine, fire or
the like.
Important Safety Instructions
Read these instructions.
Keep these instructions.
Heed all warnings.
a
b
c
d
e
f
g
Follow all instructions.
Apparatus shall not be exposed to
dripping or splashing.
n
o
Do not use this apparatus near water.
Clean only with dry cloth.
Do not place any sources of danger on
the apparatus (e.g. liquid filled objects,
lighted candles).
Do not block any ventilation openings.
Install in accordance with the
manufacturer’s instructions.
This product may contain lead and
mercury. Disposal of these materials
may be regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
p
Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
h
i
Protect the power cord from being
walked on or pinched, particularly at
plugs, convenience receptacles, and the
point where they exit from the apparatus.
Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
q
r
Only use attachments/accessories
specified by the manufacturer.
j
k
Only use power supplies listed in the user
manual.
Unplug this apparatus during lightning
storms or when unused for long periods
of time.
Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
l
3
EN
•
Consult the dealer or an experienced
radio/TV technician for help.
Warning
• Never remove the casing of this apparatus.
• Never lubricate any part of this apparatus.
• Never place this apparatus on other electrical
equipment.
• Keep this apparatus away from direct sunlight, naked
flames or heat.
• Ensure that you always have easy access to the power
cord, plug or adaptor to disconnect this apparatus from
the power.
This device complies with Part 15 of the FCC
Rules and RSS standard of Industry Canada.
Operation is subject to the following two
conditions:
1 this device may not cause harmful
interference, and
2 this device must accept any interference
received, including interference that may
cause undesired operation.
RF Radiation Exposure Statement: This
equipment complies with FCC’s and IC’s RF
radiation exposure limits set forth for an
uncontrolled environment.The antenna(s)
used for this transmitter must be installed and
operated to provide a separation distance of
at least 20 cm from all persons and must not
be collocated or operating in conjunction with
any other antenna or transmitter. Installers must
ensure that 20cm separation distance will be
maintained between the device (excluding its
handset) and users.
Notice
Any changes or modifications made to this
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Notice for the USA
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules
and ICES-003 of Industry Canada . These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.This equipment generates, uses,
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instruction manual, may cause harmful
interference to radio communications.
Notice for Canada
This Class B digital apparatus complies with
Canadian ICES-003.
This device complies with Industry Canada
licence-exempt RSS standard(s): Operation
is subject to the followingTwo conditions:(1)
this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
Disposal of your old product
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products and batteries.
The correct disposal of these products helps
•
•
Relocate the receiving antenna.
Increase the separation between
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
EN
4
prevent potentially negative consequences on
the environment and human health.
additional information on a recycling center in
your area.
the use of this accessory with iPod or iPhone
may affect wireless performance.
iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries.
Always bring your product to a professional to
remove the built-in battery.
Note
• The type plate is located on the bottom of the
apparatus.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
The making of unauthorized copies of copy-
protected material, including computer
programs, files, broadcasts and sound
recordings, may be an infringement of
copyrights and constitute a criminal offence.
This equipment should not be used for such
purposes.
“Made for iPod” and “Made for iPhone”
mean that an electronic accessory has been
designed to connect specifically to iPod or
iPhone respectively, and has been certified by
the developer to meet Apple performance
standards.Apple is not responsible for the
operation of this device or its compliance with
safety and regulatory standards. Please note that
5
EN
2 Your Docking
Speaker
Overview of the main unit
b
c
d
Congratulations on your purchase, and
welcome to Philips!To fully benefit from the
support that Philips offers, register your product
e
f
a
If you contact Philips, you will be asked for the
model and serial number of this apparatus.The
model number and serial number are on the
bottom of the apparatus.Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
gh
i
Introduction
a iPod/iPhone dock
With this docking speaker, you can enjoy audio
from the iPod/iPhone, Bluetooth-enabled
devices, and other external audio devices.
b
•
Turn on/off the unit.
c
•
Select Bluetooth source.
What's in the box
d VOLUME
•
Adjust volume.
Check and identify the contents of your
package:
e Bluetooth indicator
f Power indicator
g 10V DC
•
•
•
Main unit
1 x AC adaptor
Short user manual
•
Power supply socket.
h AUDIO IN
•
Connect an external audio device.
i Stand
EN
6
Connect the AC power adaptor to:
3 Get started
•
the power supply socket on the back of
the docking speaker.
•
the wall power outlet.
Caution
• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
10V DC
If you contact Philips, you will be asked for the
model and serial number of this apparatus.The
model number and serial number are on the
bottom of the apparatus.Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Built-in Battery
The docking speaker can also operate on built-
in rechargeable battery.
Prepare the docking speaker
» The speaker mute when the battery
level is low.
Pull the stand upwards from the unfixed end.
Battery power
Low
LED indicator
Flashing fast
Medium
Full
Flashing slowly
Steadily on
To recharge the built-in battery:
•
Connect the unit to the power supply.
Note
Connect power
•
Use only the supplied AC adapter to charge the
battery.
Caution
• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the unit.
• Risk of electric shock! When you unplug the AC
adaptor, always pull the plug from the socket. Never
pull the cord.
• Before connecting the AC adaptor, Make sure that you
have completed all other connections.
Turn on
Slide on the docking speaker to the ON
position.
» The power indicator turns on.
The speaker turns to standby mode when there
is no audio detected for over 15 minutes.
7
EN
Charge the iPod/iPhone
4 Play
When the docking speaker is connected to wall
power outlet, the docked iPod/iPhone begins
to charge.
Play from iPod/iPhone
Tip
• You can also charge your iPod/iPhone through the
built-in battery.
You can enjoy audio from iPod/iPhone through
this docking speaker.
Compatible iPod/iPhone
The docking speaker supports the following
iPod/iPhone models.
Play from Bluetooth device
Made for :
Note
•
•
•
iPhone 5
iPod nano (7th generation)
iPod touch (5th generation)
• The effective operation range between the docking
system and the paired device is approximately 10
meters (30 feet).
• Keep this docking speaker away from other electronic
devices that may cause interference.
Load the iPod/iPhone
Insert your iPod/iPhone into the dock.
1 Slide to select Bluetooth source.
» The Bluetooth indicator blinks.
2 Activate the Bluetooth function in your
Bluetooth device (see the device user
manual).
3 Select “PHILIPS DS7880” displayed on
your device for pairing.
» If connection is successful, the
docking speaker beeps twice, and the
Bluetooth indicator stops flashing.
To remove the iPod/iPhone
•
For some devices, you need to input
"0000" as pairing password.
•
Pull your iPod/iPhone out of the dock.
4 Start music play on your Bluetooth device.
Listen to the iPod/iPhone
Note
• Make sure that the iPod/iPhone is loaded correctly.
• Make sure that you deactivate bluetooth connection by
sliding to the OFF position.
•
Start music play in your iPod/iPhone.
» You can hear music from this docking
speaker.
EN
8
5 Product
information
Play from an external device
You can also listen to an external audio device
through this docking speaker.
1 Connect the MP3 link cable (not supplied)
Note
to:
•
the audio in socket (3.5mm) on the
back of the unit.
• Product information is subject to change without prior
notice.
•
the headphone jack on an external
device.
2 Start to play on the device (see the device
user manual).
Specifications
Amplifier
Rated Output Power
Signal to Noise Ratio
Audio in
2X5 W RMS
75 dB
0.6V RMS 22
kohm
AUDIO IN
Bluetooth
Bluetooth version
Frequency band
V2.1+ EDR
2.402-2.480 GHzISM
Band
Adjust volume level
Rang
10m (free space)
•
During play, press VOL +/- to increase or
decrease the volume level.
General information
AC power (power
adaptor)
GFP241DA-1024B-1
Input: 100-240V~,
50/60Hz, 0.55A;
Output: 10V 2.4A;
10W
Operation Power
Consumption
Dimensions
- Main Unit (W x H
x D)
310 x 105 x 41mm
0.65 kg
Weight
- Main Unit
9
EN
6 Troubleshooting
Warning
• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome).When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
•
•
•
Make sure that the docking speaker is fully
charged.
Make sure that the AC power plug of the
unit is connected properly.
Make sure that there is power at the AC
outlet.
No sound
•
Adjust volume on your mobile phone or
PC/Mac.
•
Make sure that your Bluetooth mobile
phone is within the effective operation
range.
•
Check if you have selected the correct
audio source.
No response from the unit
•
Disconnect and reconnect the AC power
plug, then turn on the docking speaker
again.
EN 10
Specifications are subject to change without notice
2014 ©WOOX Innovations Limited.
All rights reserved.
This product was brought to the market byWOOX Innovations Limited or one of
its affiliates, further referred to in this document asWOOX Innovations, and is the
manufacturer of the product. P&F is the warrantor in relation to the product with
which this booklet was packaged. Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V.
DS7880_37_UM_V2.0
|